Technical data:
- Cat 7 connection module
- Connection module perfectly suitable for CAT.7 network cables, ATM and multimedia networks
- Transmission speed up to 10/100/1000/10000 Mbit/s (10 Gigabit Ethernet)
- Operating frequencies up to 500 MHz (tested with 600 MHz)
- Downward compatible with other transmission standards: CAT.5e, CAT.5, CAT.6, Cat.6A , Cat.7
- for AWG 24 - 22 installation cables with core diameter 1.0 - 1.6 mm
- supported cable outer diameter: 5.0 - 9.0 mm
- Cable clamp sets for different cable diameters are supplied
- connects / repairs Ethernet (network), Internet or ISDN cables
- Shielded housing (metallised, refined plastic housing)
Assembly instructions:
- Cut off approx. 70mm of the cable sheath.
- Twist the braided shield together and lay it back over the cable sheath so that there is a contact surface.
- Fasten the cables with suitable cable clamps.
- Run the cable cores to the LSA terminals and trim the excess foil shielding of the individual core pairs. When connecting the wire pairs, make sure to lead the pair shields as close as possible to the LSA terminals and shorten them accordingly.
- Clamp the individual cores according to the wiring diagram using an LSA laying tool. Pay attention to the strand colour. This must be adhered to exactly.
- Close the housing of the junction box.
Scope of delivery:
- 1 x LSA connection box CAT.7
Technical data:
- Cat 7 connection module
- Connection module perfectly suitable for CAT.7 network cables, ATM and multimedia networks
- Transmission speed up to 10/100/1000/10000 Mbit/s (10 Gigabit Ethernet)
- Operating frequencies up to 500 MHz (tested with 600 MHz)
- Downward compatible with other transmission standards: CAT.5e, CAT.5, CAT.6, Cat.6A , Cat.7
- for AWG 24 - 22 installation cables with core diameter 1.0 - 1.6 mm
- supported cable outer diameter: 5.0 - 9.0 mm
- Cable clamp sets for different cable diameters are supplied
- connects / repairs Ethernet (network), Internet or ISDN cables
- Shielded housing (metallised, refined plastic housing)
Assembly instructions:
- Cut off approx. 70mm of the cable sheath.
- Twist the braided shield together and lay it back over the cable sheath so that there is a contact surface.
- Fasten the cables with suitable cable clamps.
- Run the cable cores to the LSA terminals and trim the excess foil shielding of the individual core pairs. When connecting the wire pairs, make sure to lead the pair shields as close as possible to the LSA terminals and shorten them accordingly.
- Clamp the individual cores according to the wiring diagram using an LSA laying tool. Pay attention to the strand colour. This must be adhered to exactly.
- Close the housing of the junction box.
Scope of delivery:
- 1 x LSA connection box CAT.7