Out of stock

Satfinder Digital hb-digital SF-99

SKU: 5393 - BW

GTIN: 4063328013318

Category: Satfinder refurbished

Item currently out of stock

Notify me when available

Currently out of stock

hb-digital satellite finder - your best choice among SAT measuring devices
Built-in compass
LCD Screen
LED backlight
Digital display
Very easy to use

Important: The device offered is a customer return or demonstration device. After our internal check, the device proved to be fully functional and is in good condition. There are slight signs of wear on the housing and the box. It may be that the original box was replaced because it was too badly damaged.

More product details

HB-digital Satfinder Digital SF-99 for setting your digital or analogue satellite system.

This digital SATFINDER is microprocessor-controlled and therefore reliable and precise.
The signal strength is displayed graphically on an LCD display in the form of a thermometer scale and in numbers (0-99).
In addition, the device can emit high-pitched tones via a buzzer (the higher the tone, the better the signal).
This digital SATFINDER is very sensitive and can detect even the weakest signal.
Strong input signals (from powerful satellites, large satellite dishes) can easily be attenuated for better readout.

High-quality refined SAT connections ensure clean and excellent signal transmission as well as unique corrosion protection.
It is simply connected between the LNB and receiver using a connecting cable.

Technical data:

Input frequency: 950-2150MHz
Input level min.: -40dBm
Input level max.: -10dBm
Input impedance: 75 ohms, F-connector
Operating range: 52~60dB
Power supply: DC 13-18V
Size: 13x6.8x2.5cm (LxWxH)
Screen size: 5.7x 1.7cm (LxW)

Specifications:

Under the following test conditions: LNB Gain = 55dB, Carrier C/N = 15dB.
When operating an LNB with a gain of 60~65dB, use a 5dB attenuator.

Quick start Guide:

Connect the LNB cable to the “Satellite” marked port on the SAT finder.
Connect the cable from the receiver to the port marked “Receiver”.
On the receiver, select the transmitter or transponder whose signal quality you want to improve.
Turn the rotary knob on the side until the display shows approx. 50% of the signal strength.
Turn the satellite dish slowly until the signal strength increases. Then reduce the signal strength again to approx. 50%. Repeat the process until the signal strength no longer increases.

Scope of delivery: